501 Ford Mower

EHewitt

New User
I am in need of the cutter bar yoke p/n 147783 for my Ford 501 sickle mower. Anybody have a used one? This is the casting w/ the 2 eccentrics in it for adjusting cutter bar lead and it rotates front / back 10 degrees to adjust tilt of cutter bar w/ ground. Thank you!
Eric
 
Do you have a picture of it?? I have parts and pieces of a couple old ford sickle bar mowers but not sure if I would have the part you needed. Also not sure if what I have is a 501 or a 515 or both
 
(quoted from post at 10:54:05 07/05/16) Do you have a picture of it?? I have parts and pieces of a couple old ford sickle bar mowers but not sure if I would have the part you needed. Also not sure if what I have is a 501 or a 515 or both

The 501 is a wooden pitman stick model and the 515 is a belt and wobble box model. The yoke is not the same. I am in need of the one for a wooden pitman stick model. I will try to get a photo on here tomorrow however there are good photos when you google parts for the 501 that may look more descriptive than I can get. Thank you!
 
(quoted from post at 12:51:46 07/05/16)
(quoted from post at 10:54:05 07/05/16) Do you have a picture of it?? I have parts and pieces of a couple old ford sickle bar mowers but not sure if I would have the part you needed. Also not sure if what I have is a 501 or a 515 or both

The 501 is a wooden pitman stick model and the 515 is a belt and wobble box model. The yoke is not the same. I am in need of the one for a wooden pitman stick model. I will try to get a photo on here tomorrow however there are good photos when you google parts for the 501 that may look more descriptive than I can get. Thank you!

There is a "K18" casting number on the yoke and it has 2 grease fittings (one for each eccentric pivot) Thanks
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top