(800) 853-2651
SHOP NOW

International 240 Utility Hydrolics

T

triple-n-farm

New User
I have a 240 that is mixing the hydrolic fluid into the oil, Took the pump off to see if it is mixing at gear not for sure. had the same problem fixed a year ago, it worked fine until had to use a little more. Hate to send to shop every year to get fixed, anyone have a suggestion how to fix :?:
 
First of all your FIX last year most likely was not a true fix. Most mechanics see that the fluid I going in around the pump shaft so they pull the gear and replace the seal. THAT most of the time will buy a few months but is not a FIX. That shaft seal only seals drip pressure. The end plates get wore in the pump and hydraulic oil is building pressure where there is not supposed to be pressure, so replacing the seal does not completely stop your problem. Solution is replace the pump UNLESS you have a good pump repair shop. Most times the repair requires re surfacing the end plates in the pump and cost will be more than the cost of a new pump. BTDT
 
(quoted from post at 17:28:26 06/27/16) First of all your FIX last year most likely was not a true fix. Most mechanics see that the fluid I going in around the pump shaft so they pull the gear and replace the seal. THAT most of the time will buy a few months but is not a FIX. That shaft seal only seals drip pressure. The end plates get wore in the pump and hydraulic oil is building pressure where there is not supposed to be pressure, so replacing the seal does not completely stop your problem. Solution is replace the pump UNLESS you have a good pump repair shop. Most times the repair requires re surfacing the end plates in the pump and cost will be more than the cost of a new pump. BTDT
Click to expand...

So that is probably why I have a heat problem with the hydrolics, tends to warm up thought I needed to put some kind of cooler on it.
 
You must log in or register to reply here.

Similar threads

D
Retirement
2 3
Replies
51
Views
4K
dcarp
dcarp
M
Ford 9N governor internal question
Replies
1
Views
185
wore out
wore out
N
930 hydraulic problems
Replies
5
Views
280
Northm
N
T
Weak PTO on IH 300 Utility
Replies
4
Views
249
MARK ROBKE
M
W
40 series SCV housing leaking
Replies
3
Views
223
Weston Bend
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top