(800) 853-2651
SHOP NOW

430 twine baler

R

rkc9700

Member
having knotter trouble with this baler , left sides works great , right side , NOT!! can anyone help me? I've been told these IHC balers and their knotters are a pain, no one around heres knows anything about them. they are different from other knotters I know. please let me know if anyone can help and we will go from there . thanks
 
Hi, does it have the "All Twine" knotters? If not then most likely problem is dull twine knife or twine being poor quality (thick and thin spots). Is the untied twine long enough to go around the bale? If to short the held end of twine could be slipping out of twine holder disk.

JimB
 
YES , ALL TWINE yes the twine is same length as other side , can tie them off , but its a pain. no one really knows about these knotters around here
 
Hi, unfortunately I can't help you much on "All Twine" knotters as they are usually so good that no one every works on them. All I can say is tip the knotter up, clean all the crap out of it, inspect bill hook for wear and compare it to the working one, sharpen the twine knife. Next put knotter back in place and turn baler over by hand and trip the knotter and watch and compare both knotters. Watch the twine placement in the bill hook and how much tension it takes to trip the bill hook. I can't remember on IH if stripper arm strips the knot off the bill hook or not or only cuts the twine.

Check youtube as there were some good videos a few years ago about how a NH knotter works. The IH "All Twine" knotter is very similar.
PS, my brother has an IH 430 and 435 with "All Twine" knotters and they work perfectly with plastic twine. Therefore I have no experience on them but lots of experience on the old style IH knotters.

Good luck
JimB
 
You must log in or register to reply here.

Similar threads

B
IHC 430 435 Balers
Replies
3
Views
202
dairyman
dairyman
Tom in TN
Replacing knotter shaft on a NH 273 baler
Replies
4
Views
255
Tom in TN
Tom in TN
B
IHC 430 And 435 Balers
Replies
1
Views
287
VicS
V
Tom in TN
Stilll working on NH 273 baler
Replies
6
Views
358
DanielW
D
W
NH 277 wire to twine tie conversion
Replies
7
Views
470
WYDesertFarm
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top