(800) 853-2651
SHOP NOW

Why mow with A 48 inch mowet?

Geo-TH,In

Geo-TH,In

Well-known Member
Because you broke a two foot blade off a 72 inch mower.
a229212.jpg
 
And why does the mower make such a racket? Because SWMBO ran over a stump and bent a blade. Then there was the chicken wire incident. Then yesterday I caught her starting the yard mowing but didn't have the blades engaged. She didn't know because her ear buds were turned up so loud.

That's what happens when you marry from the city. That engine on her mower can't blow soon enough.
 
I got too close to a stump. I knew it was there, just got too close. I run the 540 rpm woods pto closer to 600 rpms. The blades are singing in the wind. The good news is only bent the blade, have spares and snapped the bolt, which I got out easier than I thought. Going to cover the stump with dirt on Monday. Lesson learned. Doesn't look like spindle got damaged, I hope. That would be costly and take time to get, special order. geo.
 
That sounds just like my wife! The first summer we got married, she wanted to mow the lawn, I soon realized it was a lot easier to just do it myself! Now the mower never gets stuck or breaks.
 
Now guys its OK to marry from the CITY. I admit I lucked out and married a North End Chick. North-End of Dubuque Iowa that is. My wife can and has done about everything on the farm. Told all her friends when she grew up she was going to have a ranch. Well I guess this old pile of dirt is about as close as she will come. This morning we did about a 1/4 mile of Gaucho fence, only complaint was she lost her little bottle of Deet. Don't worry I will find it for her....after all it the only bottle out there....
 
I cover stumps with a junk tire and a quart of gasoline,light it off just before dark.
 
You must log in or register to reply here.

Similar threads

Geo-TH,In
24 hp 48 inch husqvarna transaxle?
Replies
13
Views
633
Geo-TH,In
Geo-TH,In
T
What do think, snow blade
Replies
3
Views
927
stevieb49829
stevieb49829
R
Sharpening rotary mower blades
Replies
5
Views
714
MARK ROBKE
M
D
Farmall 300 clutch update
Replies
4
Views
219
used red MN
U
Geo-TH,In
Not all 1/2 x 86 inch v belts are the same length.
Replies
19
Views
700
Geo-TH,In
Geo-TH,In
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top