I found a 12V battery with the end of the case melted away. I suspected that the other cells were OK, they were. I used a sawsall to carefully cut ONLY the plastic case all the way around the 2nd cell, ( beside the melted one) I also cut around the top seam of those dead cells. Then I carefully remove the plastic exposing the plates.Then I cut the plates off of the bottom of lead bar from the 4th/ 5th cell. Rinse the battery thoroughly. To install, connect battery post as usual. other end, strip battery cable insulation off about 1 1/2", now lay the cable on the lead bar, and clamp them together. Good to go!
- Thread starter CCer
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy