24T wiper arm roller replacement

Bkpigs · Apr 24, 2016

How do you replace the roller on the wiper arms of a JD 24t baler. Mine have a good amount of wear and before I order them I figure I should know how they come off. I haven't removed the wiper arm off yet but the times I did have them off in years past I don't remember a pin or something on the end that holds them on. Any ideas?? Thanks

Northvale PA · Apr 24, 2016

I believe they are held on with a spring clip

Roger in Iowa · Apr 25, 2016

Early knotters had a washer that was held on by riveting the wiper arm material to hold the washer and arm. Later parts have a snap
ring only.

BradyW · Apr 25, 2016

If it is the original part the roller bushing on the end is press/peened on and can not be changed, if you purchase a new one from deere about $ 280.00 it comes with a snap ring on the top side so it can be replaced. Also the cutter knife is replaceable with screws.

Bkpigs · Apr 25, 2016

OK, thanks. That is what I was thinking, as I do have the older style.

24T wiper arm roller replacement

Bkpigs

Member

Northvale PA

Member

Roger in Iowa

Well-known Member

BradyW

Member

Bkpigs

Member

Similar threads