Jerry Belcher Jr
New User
What front loader did John Deere install on a 1973 1020 there are several listed that say will fit but not sure if all will without modification
- Thread starter Jerry Belcher Jr
- Start date
A John Deere 46 and 146 loader would fit. For a newer loader then you would want a JD 520 loader. Even if it had the longer four cylinder bracket it will also have the holes for the three cylinder about six inched in front of the four cylinder mounting holes. You cut the bracket off and bolt it up.
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
37,47,100,143,145.175
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy