Grandpa's Planter

cool hand

Member
Location
SE IN
This is my granddad's planter from ca. 1900. They always called it "the corn drill." It had one seed plate and two speeds for plant spacing, 16 - 0 - 20 inches, I suppose. In the seed box there is a brush, like a large shaving brush, that rubbed against the seed plate just before the drop tube to diminish multiple drops, and a steel "knocker" directly above the drop tube. Usually pulled it with one horse.
a212088.jpg

a212089.jpg

a212090.jpg
 
I have my Grandpa's horse drawn cotton planter under a shed. Will try to post photos of it tomorrow.
That is a neat planter.
Richard in NW SC
 
I also have my Grandpa s old planter. It is A one row horse drawn Kelly planter. I have A few difference plates with it It all works good, but I don t use it.
I have 9 of these old horse drawn equip from my Grandpa s old farm.

Hammer Man
a212097.jpg

a212099.jpg
 
Put a little grease and oil on it and looks like you could go plant with it tomorrow. That patch job on the broken handle should hold good enough for another season.
 
We'll keep it around as an interesting heirloom. Our heirs will probably sell it or one will keep it as "yard art" until it disintegrates. Don't know about the make, there may be a trademark on it somewhere. You may be right about the "Hoosier," we are located in SE IN. We have used it a few times to fill in skips in a bad stand of corn--recently enough to have been pulled by an ATV! LOL!
 
I was thinking Oliver made that one, but may be mistaken. I do remember seeing planters with that drive set-up and that style front wheel when I was a kid, but didn't really pay that close attention then.
 
You must be really good at where's waldo ! I had to go back a couple of times after reading this to find it.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top