(800) 853-2651
SHOP NOW

Not moving

N

Nick167

Member
I seen this 1600 for sale since it looked cheap I started talking to him its got a fresh motor new tires but he said he was hauling hay with it and it stopped he thinks it's stuck in gear but it will roll? It doesn't have a hydra power just a 4spd he's asking 1450 any chance it's a simple fix? Or should I run?
a212057.jpg
 
Will the shift move? I can't figure it rolling if it's stuck in gear,or more likely two gears. Any chance the clutch let loose? That sounds more likely. The price probably isn't bad. I'd take it for that,but then,I've got another one here for parts.
A 4 speed doesn't sound right either though. They were 6 speed with 2 reverse if they didn't have hyrda power.
 
Could be the clutch. Do the hydraulics and pto still work? Neighbor had a chain coupler fail once where it was still coupled together by the chain but no longer turned the input shaft on the transmission.
 
Maybe the thing ahead of the transmission is what is locked up.

When I was hauling iron, we couldn't get an 88D started in WI because of the cold. We were pulling it and the wheels were turning but not the fan. The clutch was slipping.
 
(quoted from post at 15:42:41 01/20/16) I seen this 1600 for sale since it looked cheap I started talking to him its got a fresh motor new tires but he said he was hauling hay with it and it stopped he thinks it's stuck in gear but it will roll? It doesn't have a hydra power just a 4spd he's asking 1450 any chance it's a simple fix? Or should I run?
a212057.jpg
Click to expand...

It looks like one you could make some money on with a little work. Most likely the clutch, and many people are afraid of a split. with the new motor and tires you can't go wrong if it starts and runs.
 
The bypassed air cleaner and short chrome straight pipe suggest it was setup for tractor pulls rather than for farming.
 
You don't have to split an Oliver to put a clutch in them. With no hydra power,you wouldn't even have to pull the motor. A two hour job.
 
Nick,you said it's three and a half hours from you. If it's up toward Michigan,I'd be interested. Send me an email if it is would you?
 
You must log in or register to reply here.

Similar threads

super99
Oil Leak
Replies
4
Views
705
super99
super99
1
JD 4430 just stopped moving
Replies
10
Views
1K
Joe Stewart
J
C
Didn't get home until almost 2am this morning
Replies
8
Views
603
Crashfarmer
C
T
Case 530 CK parked for 10 years
2 3 4
Replies
78
Views
2K
TapRackFire
T
Momo Taro
Let's fix this DB 885
2
Replies
32
Views
1K
Momo Taro
Momo Taro
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top