A little strange and funny: Week before last, I needed a wrench that was too thick to make a repair to my tractor.
I went outside ,set a small drill press vise on a stool, and proceeded to grind down the sides of wrench with a 4" disc grinder.
While grinding, a small black bee kept flying close to work piece.
When I stopped grinding, it went away but kept coming back after I started grinding again.
Since it would not come back while just running the grinder, I suspect the vibrations during grinding is what it was coming to.
Several days later, I needed another backup wrench and the same thing happened again.
Just thought this was strange and wanted to share.
I went outside ,set a small drill press vise on a stool, and proceeded to grind down the sides of wrench with a 4" disc grinder.
While grinding, a small black bee kept flying close to work piece.
When I stopped grinding, it went away but kept coming back after I started grinding again.
Since it would not come back while just running the grinder, I suspect the vibrations during grinding is what it was coming to.
Several days later, I needed another backup wrench and the same thing happened again.
Just thought this was strange and wanted to share.