186 Hydro

Allan in NE · Sep 19, 2015

And here I thought this was a simple little seal replacement.

Allan

glennster · Sep 19, 2015

Kinda looks like somethin broke in there!

Greg K · Sep 19, 2015

Can you just put the rollers back in there?

keh · Sep 19, 2015

Was that a sealed bearing? Looks expensive anyway.

KEH

Bob · Sep 19, 2015

Well, at least you stopped before the axle and wheel fell out of the tractor!

todd hamilton · Sep 19, 2015

That's worn out

Allan in NE · Sep 19, 2015

Pretty much. :>)

Allan

Janicholson · Sep 19, 2015

I'd polish that shaft some before pulling the race off with the big tractor!.. Jim

pete 23 · Sep 19, 2015

Well, you didn't have to put a dial indicator on the axle to see if you had too much play. I used to put a old plow beam, turned upside (pointing up) down on the end of the cherry picker to get those axle housings off from under the cabs. You will most likely have contamination in the main rear housing also and just hope it hasn't chewed up the bull gear from flopping around.

JD Seller · Sep 19, 2015

Well look on the bright side. YOU do not have to hunt for the problem!!! LOL Wish you well on the total repair. I know you have had a bit of bad luck lately with repairs blooming out of control.

Gchase24 · Sep 19, 2015

Got all your money's worth out of that one.

scott mcintosh · Sep 19, 2015

At least it is not the inside bearing,been there done that.Scott

GordoSD · Sep 19, 2015

Your camera is working 110 %

37chief · Sep 20, 2015

Looks like you're about to have some fun. Stan

2510Paul · Sep 20, 2015

Look at the bright side. At least you don't have to wonder if the bearing is good>

Paul

186 Hydro

Allan in NE

Well-known Member

glennster

Well-known Member

Greg K

Well-known Member

keh

Well-known Member

Bob

Well-known Member

todd hamilton

Member

Allan in NE

Well-known Member

Janicholson

Well-known Member

pete 23

Well-known Member

JD Seller

Well-known Member

Gchase24

Member

scott mcintosh

Member

GordoSD

Well-known Member

37chief

Well-known Member

2510Paul

Well-known Member

Similar threads