Last Call!!

Bryce Frazier · Aug 16, 2015

I am scrapping a Massey Harris 101 Sr. and a New Holland 66 baler tomorrow. If there is anything you want, shoot me an e-mail. Just pay the freight!

Bryce

JRSutton · Aug 16, 2015

You should consider pulling the needles and knotters from the baler. There's always somebody needing them, and they're getting real hard to come by. You'll really make somebody's day if you save them.

I've got extras for my own. What I do need though is a gear case - but way too heavy to ship unfortunately!

44 massey · Aug 16, 2015

Will be rebuilding my 101 sr so if you could post a pic will take a look and see if you have anything I need!! Do know I need the rear lower engine side panels!!! Thank You

Bryce Frazier · Aug 16, 2015

OH ya! I have the needles, knotters, and a few other things that are good things to keep as "spares"...

Actually, Needles might still be on it now that I think about it..... Good thing you said something!!! I will go check that out right now!!!

"44 Massey";

I will be back with a picture in a few minutes! VERY little left of the MH 101 though....

Bryce

Traditional Farmer · Aug 16, 2015

You might want to take the tongue off the baler they're handy for a lot of things if nothing else you can weld a hitch on the back end and make a good push/pull pole.

JMS/.MN · Aug 16, 2015

Take the bale counter off. Minor item, but handy to keep track of loads, etc. I found several in my favorite junk yard, put one in each tractor for chopping hay, silage. Keep the pto driveline, wheels, axles. I used the flywheel for a buried base for the mail box support.

Traditional Farmer · Aug 17, 2015

Since you're looking at another NH baler you'd do well to keep this one as many NH
parts stayed the same over the years

Last Call!!

Bryce Frazier

Well-known Member

JRSutton

Well-known Member

44 massey

Member

Bryce Frazier

Well-known Member

Traditional Farmer

Well-known Member

JMS/.MN

Well-known Member

Traditional Farmer

Well-known Member

Similar threads