Farmall H removal

lmswanson · May 16, 2015

So I need to remove the radiator from my 1941 Farmall H. On our M it was easy to get the two nuts off because there where two holes in the frame. On te H there is no holes and because of a pole in the middle an end wrench won't work. So how should I do it?

David G · May 16, 2015

My 51 H had holes for the bolts.

Zachary Hoyt · May 16, 2015

It can be done from the back as I remember. Of the Hs I dismantled fewer than half had holes for the radiator bolts. It is a slow and tedious process of 1/6 turn at a time. Best of luck.
Zach

flying belgian · May 16, 2015

Can you make holes?

used red MN · May 16, 2015

Did the H and M you are talking about both have wide front ends on them?

David G · May 16, 2015

Good point, my H is narrow front.

lmswanson · May 16, 2015

The M was a wide front end but was turned into a narrow front end the H has always been a narrow front end

Icuby · May 16, 2015

The early Farmall H did not have holes in the casting below the rad for access to rad.bolts.

Farmall H removal

lmswanson

New User

David G

Well-known Member

Zachary Hoyt

Well-known Member

flying belgian

Well-known Member

used red MN

Well-known Member

David G

Well-known Member

lmswanson

New User

Icuby

Member

Similar threads