pto pump vs remote(MF-65)

Rkh · Apr 7, 2015

have a chance to buy a remote for $275 plus shipping pictured. will this work as well as my pto pump so I can free pto. I'm afraid the remote wont work as fast or wll be slow. Also how does this work if you mount it on top of tranny behind seat(mf-65). There must be some kind of pump it hooks up to

LP GAS ONLY · Apr 7, 2015

I bet it will not be as fast as your pto pump.
Why not do a front mounted pump off of the crank?

Rkh · Apr 7, 2015

Older model mf65 had tie rod in the way.

Dave Sherburne, NY · Apr 7, 2015

My FIL had a MF 65 back in the 60s with one of these on it. Tractor wasn't very old and the valve was new. As I recall, there is a plate on top of the transmission that you remove and replace with this valve. Under the plate is a tube that goes down to the pump. in the tractor and that's where the hydraulic fluid comes from to run one external cylinder with this valve. After you take the plate off everything has to be clean, and use new O rings when you put it on. Hoses just hook to the valve with the proper fittings and then you have to figure out how the levers work. As I recall, one lever is to go from internal to external Hydraulic and the other operates the external cylinder. Ask your question down on the M F board, those guys can help you.

Bob N.Y. · Apr 8, 2015

The flow rate of the internal pump on a 65 is 4.2 gallons per minute. What is your pto pump rated at? You can replace the steering arms on top of the spindles with the newer, shorter style and use a front pump.

Bret4207 · Apr 9, 2015

That's what I have on my 65. It goes under the seat with lever between your legs. Mine works good. The thumbscrews on the back determine 1 way or 2 way hydraulics.

pto pump vs remote(MF-65)

Rkh

Member

LP GAS ONLY

Member

Rkh

Member

Dave Sherburne, NY

Member

Bob N.Y.

Well-known Member

Bret4207

Well-known Member

Similar threads