KCTractors
Member
- Location
- Central Wi
Just wondering if a power-adjust rear rim from a Allis Chalmers WD fit on a Massey 50 power-adjust hub with four rails?
- Thread starter KCTractors
- Start date
Ultradog MN
Well-known Member
- Location
- Twin Cities
Are you talking about the rim itself or the whole center too?
The lug bolt pattern on the WD would be 8 on 8" with I think 5/8" studs.
Ford used those PA rims with the rails on some of the Thousand Series too but the centers were usually 8 on 6".
I have a set of 28" PA rims here with the rails like the WDs had. I knocked the old tractor over the head yesterday and she will go to parts.
They're available...
The lug bolt pattern on the WD would be 8 on 8" with I think 5/8" studs.
Ford used those PA rims with the rails on some of the Thousand Series too but the centers were usually 8 on 6".
I have a set of 28" PA rims here with the rails like the WDs had. I knocked the old tractor over the head yesterday and she will go to parts.
They're available...
KCTractors
Member
- Location
- Central Wi
Just the rim itself.
Brendon Warren
Well-known Member
Yes they are the same. Wheel weights interchange as well.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy