Schwartz Front End Question

2510Paul · Jul 14, 2014

I am putting a used Schwartz front end on a 3010 JD. Most of you know the 3010 has a 4 bolt mount to the steering motor up front. I notice in the catalog the correct steering arm on a Schwartz front end has a four bolt matching mount. The used one I have only has an arm with holes for two bolts. Question, has anyone seen any adverse affects like loosing the two bolts in this arrangement?
The correct arm is $80 at A&I so I just soon use what I have if I can trust it. Thanks. Paul

DeltaRed · Jul 14, 2014

Two holes will be fine.Just make sure the bolts are tight.Keep em tight,too.

2510Paul · Jul 14, 2014

Thanks Delta. I will use medium Loctite. It is for a friend so after it leaves me I will not be able to check it.
By the way Delta, I purchased a JD 4200 3 bottom 18" rollover plow. I got the manual to learn how to set it up. I don't think that plow was ever setup properly in it's life. Heavy plow but pulls easy when set properly. Recall this last spring I was asking about roll-over plows.
Paul

Schwartz Front End Question

2510Paul

Well-known Member

DeltaRed

Well-known Member

2510Paul

Well-known Member

Similar threads