tire tourniquet

SDE · Jul 4, 2014

It worked when I used a come-along.
Thank you
Steve

caterpillar guy · Jul 4, 2014

The propane tank conversion is so much easier. A new tank cut the valve out. Weld in a 2 inch nipple, then screw on a T with a nipple. Thia last nipple should be about 5or 6 inches long screw it in then hit with sledge hammer to flatten end some. The other side of T screw in a plug with a hole for the fitting to hook up the air hose. Opps need a ball valve in before the final nipple to hold air in.

37chief · Jul 4, 2014

Then there is the starter fluid method. Squart a little inside the tire, then stand back and light it. Lots of examples on youtube. Stan

Frank 41 · Jul 4, 2014

This new starter fluid does not work as well as the old stuff did. The guys that recommended putting boards between the beads were right on. Some of these tires lay down and will not come back up. This has worked for me in the past.

tire tourniquet

SDE

Well-known Member

caterpillar guy

Well-known Member

37chief

Well-known Member

Frank 41

Member

Similar threads