How to check pressure on 1066 int mcv for power steering

HTY · Apr 8, 2014

power steering not working manual does not show preswsure test for power steering pump is there a port and how much pressure shoulod you have

pete 23 · Apr 8, 2014

The IH service manual prefer you remove flow divider orfice and install flow rater to check pump and also steering pressures. You don't have to do it that way, just put a 3000psi gauge in the plug hole where orfice is in and steer to stops to read steering relief valve pressure. The relief valve should read about 1800 to 2000 psi and is readily accessible at lower rear port of mcv. If you have hydraulic clutch booster it is that port. You don't read steering pressure at that port but access the steering relief valve. They usually blow the o-ring on the valve or unscrew the staked plug in valve.

HTY · Apr 30, 2014

installed new filter while working on the steering problem did not help
have slight steering left and right
then seems as if steeing wheel locks up and can turn a little to the right and a little to the left

HTY · Aug 14, 2014

(quoted from post at 05:24:45 04/30/14) installed new filter while working on the steering problem did not help
have slight steering left and right
then seems as if steeing wheel locks up and can turn a little to the right and a little to the left

Still working on steering problem while replacing parts lost all steering installed used pump and mcv went back to having little steering like before need help

How to check pressure on 1066 int mcv for power steering

HTY

New User

pete 23

Well-known Member

HTY

New User

HTY

New User

Similar threads