(800) 853-2651
SHOP NOW

A John Deere flywheel

R

RCMcBride

New User
Got a question........I just bought a 46 A with a busted A2615R
flywheel with a good ring gear. I've got a A3264R flywheel that
came off a late model tractor but has a bad ring gear. My
question is can I just swap the rings gears out and put the
good flywheel back on the tractor? Everything appears to be
the same size but I want to get someone's opinion about it.
Thanks
 
Post this in the John Deere section. Being the two flywheels have different numbers they may not interchange. Maybe different diameters which WILL effect starter clearance.
 
Pretty sure they won't interchange. late A starter was mounted under the flywheel, early styled was in a special engine cover bracket. Good flywheel shouldn't be hard to find. Just be sure it came off a tractor with good crankshaft splines so it doesn't work loose and ruin yours.
 
There is a serial # break, between those two flywheels. 584000 starts the later flywheel. No interchange.
 
You must log in or register to reply here.

Similar threads

2
John Deere R
Replies
4
Views
839
2 Fingers
2
C
Flywheel ring gear replacement and parts found in bell housing and the case underneath the dash
Replies
10
Views
457
Camy13588
C
B
John Deere 70 Flywheel Removal Help
Replies
11
Views
658
buck2013
B
S
John Deere 6603
Replies
1
Views
285
used red MN
U
D
Looking for Flywheel John Deere H Hand Start
Replies
1
Views
225
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top