Gehl mx 100 feed grinder question

Johnathan · Mar 15, 2014

I have a gehl mx 100 feed mill need to figure out how to remove big flywheel to replace the gear behind it

Anonymous-0 · Mar 15, 2014

show us pix ,,, I am betting the flywheel has a swedge key ,and tapered shaft, nh uses them on a lot of shafts ,,there is a trick ,,something like push the wheel in by tappin ,, freeing the key ,, withdraw the key and tap the wheel,, sorry to say I had my fill of gehl and Vermeer engineering decades ago

the flying belgian · Mar 15, 2014

Oh shoot. I just did that for the neighbor about two years ago but I can't remember the specifics. You know what they say--- the mind is the first to go and I can't remember what the second thing is.

rrlund · Mar 15, 2014

I don't think I ever pulled a flywheel to change anything behind it,but I've pulled the drive pulley on the mill a few times. I used one of these bearing splitters to get that off with a big puller.
I'm thinking there might be a tapered key,then use a splitter behind it to get ahold of with a puller.

Gehl mx 100 feed grinder question

Johnathan

New User

Anonymous-0

Well-known Member

the flying belgian

Member

rrlund

Well-known Member

Similar threads