magneto shops in the Mn, SD ,Iowa area

Anonymous-0

Well-known Member
Is there any good shops that do mag work in the sw Mn, nw Ia or seSD area? I ahve a few I would like to have run on a test bench.
 
I have work on alot of magnetos and what I find that helps if I work on them while there in the engine (that is if I can work on them there in room wise). If not I pull them off and put them in my vise in the tool shed and start going to work on them. I have found in the past some just need a good cleaning and a shot of oil. They are hard to screw up and rarey every break down. Some times I find that coils need to be replaced or points, condensor or that one of the wires might need to be replace. I have never taken on to a magneto shop but good luck if you do.
 
There's Ron's Mag shop in SD. Hal
605-996-1291
PS: There's Standard Magneto in IL.
1-800-624-6386
 
I took a magneto from a 40 H to this place a few years ago. Have also taken 2 starters and a generator. I had good luck with them.

V and W
205 W Russell St
Sioux Falls, SD 57104
(605) 336-0877
 
I use to get parts from American Farm Machinery in Ottertail and New York Mills MN for Viking and Standard Twin garden tractors back in the 1960's and 70's. Hal
 
I am 50 miles north of Sioux Falls. I never knew about V&W. I will givwe them a call. I can usually get spark out of mags but I would like to run them on a stand
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top