fordman565
New User
I am doing a rebuild on a MF275. I brought the block
to a local machine shop and had the sleeves
replaced. As I was turning the crank while
installing the new pistons one of the pistons pushed
the sleeve up about 2 inches and I was then able to
grab it and pull it out by hand. What should be
done about this? I thought these were suppose to be
a tight fit and I am afraid to leave it like that
and suck the sleeve into the oil pan when I run the
engine (I have seen this happen before).
to a local machine shop and had the sleeves
replaced. As I was turning the crank while
installing the new pistons one of the pistons pushed
the sleeve up about 2 inches and I was then able to
grab it and pull it out by hand. What should be
done about this? I thought these were suppose to be
a tight fit and I am afraid to leave it like that
and suck the sleeve into the oil pan when I run the
engine (I have seen this happen before).
