Cat 2 stabilizers

David G · Nov 29, 2013

I am fabricating stabilizers for my 6610 with cat 2 3 point. If someone has them, could you tell me the width and thickness of the bar stock you have? The pins are there, but PO lost the bars.

showcrop · Nov 29, 2013

(quoted from post at 19:14:24 11/29/13) I am fabricating stabilizers for my 6610 with cat 2 3 point. If someone has them, could you tell me the width and thickness of the bar stock you have? The pins are there, but PO lost the bars.

I don't know what they look like but I can't imagine them not being adjustable on a 10 series tractor.

dustycoal · Nov 30, 2013

I made some out of 1/4" x 1 1/2 wide and they have done the job. Used metal 7/8" hole saw for the holes for the pins. Need to hook up what you need the bars for to measure hole centers. Just bent ends a little so they go on the pins. I see TS has a adjustable ones for about $40 each, but The bar still works for us. Good luck

Leroy · Nov 30, 2013

4000 & 5000 tractors that 1/4 x 1 1/2 is not enough, and factory was about 3/8" x 2". Tried that and ended up adding a piece of angle iron to stiffen.

David G · Dec 1, 2013

Thanks for the information.

I was thinking 3/8 thick by 2 1/2 with stiffener.

Cat 2 stabilizers

David G

Well-known Member

showcrop

Well-known Member

dustycoal

Member

Leroy

Well-known Member

David G

Well-known Member

Similar threads