(800) 853-2651
SHOP NOW

Cylinder repair on Bush Hog 2400 QT loader

S

Scott(MO)

Member
Hello,
Does anyone have a parts break down of the front tilt cylinders on a Bush Hog 2400 QT Loader.
It has been a lot of years since I rebuilt a cylinder. I"m sure it will come back to me. My problem is getting the end cap off. It has three dimples in the end cap I"m assuming for spanner type wrench. Anyway, I can"t figure why the cap won"t come off? Is there a wire in there that holds it? Is there something I"m missing?
So, if anyone has info or parts break down, that would be great. Thanks
 
Look at the side near the end and see if here is a small hole drilled into it. Clean it out real good and look for a small square wire. If its there then locate the end of the wire and use a small flat screw driver to force the end up and out of the hole as you turn the cap.
Walt
 
I have to rebuild one of mine this winter. Is the wire inside where you cannot see it. I have the hole but did not look inside it. Does this wire go all the way around the end cap? The parts book I had shows this wire but I could not find it. Thanks
 
You must log in or register to reply here.

Similar threads

C
Hydraulic cylinder on bush hog loader question
Replies
6
Views
449
Copotay
C
M
Bush Hog Freeman loader 3000 fit Ford 3600
Replies
3
Views
405
Eman85
E
W
JD 145 Loader Lift Cylinder Rebuild
2 3
Replies
58
Views
2K
Jim.ME
J
H
Case 310B Utility Tractor Power Steering Rebuild
Replies
17
Views
1K
BarryfromIA
B
J
IH 484 Incredibly Slow Hydraulics (Front End Loader)
Replies
11
Views
987
JoshofAllTrades
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top