(800) 853-2651
SHOP NOW

slip clutch

K

Kenfarmall

Member
Hi Guys.
I want to put a new PTO seal on my Farmall H, how do I take off the slip clutch, I took the grease connections out and removed the roll pin but the slip clutch does not come off, I thank you for any help you can give me Thanks again Ken.
 
Slip clutch or ORC? If it"s an ORRC you"ve done the correct thing and it"s stuck on the shaft splines. Try penetrating oil
 
I think you mean an over running clutch. Check real close some of them not only had the roll pin they also had a set screw 90 degrees to the roll pin. It keeps the clutch from walking.

If there is not any set screws then it is just stuck. Take a good wooden block and a BIG hammer. Hitting the shaft side ways will usually get them to rock lose. If that does not work then set a block against the rear end housing and use a long pry bar to put force on the clutch. Then rap on it again.

After you get it off, and the seal replaced, clean the spline up real well. Then anti-seize the heck out of it.

Also check the PTO shaft to see if the quill bearing is bad too. That can make the seal leak. So if it is bad replacing the seal is just a temporary fix.
 
Hi Guys.
I have looked at this OVRC again there is a bar 90 degrees to the roll pin but no screw I can push down the bar but the OVRC still does not want to come off, I have used a block of wood and a hammer but no luck Thanks again for any help.
ken.
 
Hi Guys.
I cannot get this OVRC off the roll pin is out there is no locking screw, I have beat and pulled againt it for several hours and it has not moved, there must be something holding it, but I cannot see what, any suggestions Thank you. ken
 
You must log in or register to reply here.

Similar threads

S
Hayliner 65 baler slip clutch adjustment
Replies
2
Views
179
Squirrel72
S
Ellis Kinney
Truck clutch
Replies
7
Views
521
mechanicfred
M
Joe Ferguson
MF-1428V electric PTO clutch
Replies
4
Views
258
Joe Ferguson
Joe Ferguson
E
1940 farmall H trany whine after rebuild
Replies
12
Views
630
Janicholson
Janicholson
O
8N ORC and Slip Clutch?
Replies
10
Views
1K
HFJ
H
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top