Super M TA power steering

Daniel 4020 · Aug 13, 2013

We installed power steering kit on Super M. We tee'd return line in suction line of hydraulic system. The line seemed like there was cavatation. So we tee'd into fill/breather port. We are getting oil out of breather. Oil level is at correct level. This system uses tractor's own hydraulic system. Flow control is at appropriate setting and the power steering works great. Thanks for any advice.

Mike in Mn. · Aug 13, 2013

I have a couple of these set up on Massey 44's with a flow divider, return from PS unit tee'd into factory return to reservoir, on the Massey the return goes back to the tank under the fluid level, I don't know if that would make any difference or not. Sounds to me like your getting air or foam in the system, maybe try using different oil. I'm using universal hyd. fluid, mine all work good. I also have the line from the relief on the flow divider tee'd into the return line.

pete 23 · Aug 13, 2013

I would return power steering into the reservoir drain plug.

Daniel 4020 · Aug 13, 2013

Thanks for replies. Talked to company and they also suggested to return line to drain plug fitting. We think this will remedy our problem. Thanks a lot for replies.

Super M TA power steering

Daniel 4020

New User

Mike in Mn.

Member

pete 23

Well-known Member

Daniel 4020

New User

Similar threads