(800) 853-2651
SHOP NOW

Ford 8N position control issues

S

sterlingelastic

New User
I recently bought a '48 ford 8n. When I put the position/draft control lever into the vertical position to set it in position control, the implement lifts off of the ground. It will do this regardless if the touch control is lifted or lowered. Is there some sort of calibration that I need to do to get the position control in a usable position for a brush hog? It is a foot and a half off of the ground when the touch control is fully lowered and the position control is on. Any help is much appreciated!
 
That is too high, it should only be 4-6" off the ground.
Here's a link to the "N" forum I was suggesting you post it on.
I should have posted this the first time. :oops: 8N Forum
 
(quoted from post at 21:27:58 07/22/13) I thought didnt mean to repost here. Still learning this Internet
thing. Sorry!
Click to expand...
We all started somewhere. I don't see any issue! :)
 
You must log in or register to reply here.

Similar threads

D
Belarus 822 3-Point in Position Control
Replies
0
Views
61
datacommand
D
Josh M.
Ford 3000 draft control
Replies
9
Views
731
wp6529
W
R
JD-40T 1953 Dual Hydraulic system fail
Replies
6
Views
244
Rusty wheel
R
P
Position control frozen
Replies
1
Views
289
Homegrown1
H
S
TO20 Position Control
Replies
4
Views
381
Hobo,NC
Hobo,NC
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top