560 hydraulic hose and issues

Maestro · Jul 21, 2013

Has anyone had the high pressure hydraulic hose by the clutch on a 560 Repaired? I heard they can put a flange on the metal pipe and then you purchase a shorter hose. CNH is very spendy for a new one. Also this tractor acts like the hydraulics are working all the time. Advise please.

Mark-Ia · Jul 22, 2013

Replaced one on Dad"s 560 this spring.Think it cost me $46.00 to have it made..

El Toro · Jul 22, 2013

Have a new hose made. We have Colliflower that will make one while you wait, if they're not busy.
Hal

El Toro · Jul 22, 2013

Be sure to take the old hose along. Hal

Maestro · Jul 22, 2013

How did they get the end on it where it goes in the plate?

Dr. Walt · Jul 22, 2013

I highly recommend that you go with AEROQUIP Hydraulic Hose & Fittings. I have used them for many years. The fittings are reusable & can be installed "in the field" by just about anyone, without the need for a lot of specialty tools and equipment.

Mark-Ia · Jul 22, 2013

It's a compression fitting. Used the end with the flatfitting, cut the pipe from the hose, slide the nut and compression ferule over the pipe and tighten it up.

Maestro · Jul 22, 2013

Had a hose made today in Fargo North Dakota at Fargo Tubs and Hoses. Cost was 61.00 bucks. It looks and works like new. Highly recommend. He had it ready in less then and hour. Thanks for the help.

560 hydraulic hose and issues

Maestro

Member

Mark-Ia

Well-known Member

El Toro

Well-known Member

El Toro

Well-known Member

Maestro

Member

Dr. Walt

Well-known Member

Mark-Ia

Well-known Member

Maestro

Member

Similar threads