6 bolt hub

Jake Collie · Jul 18, 2013

I took an old hay wagon and made it into a hayride wagon with the seats and stairs etc. Three of the hubs are 6 bolt 5.5" bolt circle that my old chevy aluminum wheels fit and look sharp. The other hub is a 5 bolt. Does anyone know where I can get a 6 bolt, 5.5" bolt circle hub that will fit a spindle that is 1.25" OD where the inside bearing rides and .75" OD where the outside bearing rides? The 2 bearings are approximately 2.75" apart from each other on the spindle.Any help is appreciated.

charlie n · Jul 18, 2013

AgriSuply shows one but the bearing spread is closer than what you need.Good Luck.

mkirsch · Jul 18, 2013

It might be easier to replace the entire axle. On those old hay wagons the axles were often held on with a single cross-bolt.

rustyfarmall · Jul 18, 2013

Got any other junk implements with 6 bolt hubs? One of those will probably fit.

36 Coupe · Jul 18, 2013

Chevy pickups used 6 lugs in the 50s.

greygoat · Jul 18, 2013

Try: www.baumhydraulics.com and click on hub
and axle group.
I couldn"t get any picture to come up today, but
you can phone the free 800 number and a sales
consultant will give lots of help !

504-1 · Jul 18, 2013

Take a walk through your nearest scrape yard.

fixerupper · Jul 18, 2013

Old Ford 1/2 ton pickups had five hole rims that fit. The center hole has to be made just a tad bigger, I think 4 1/8" if memory serves me right. I used to put hydraulic brakes on horse pulled wagons on 5 hole Westendorf gears using the front brakes off old Fords. The drum center had to be reamed just a bit to make them fit. Jim

cannonball · Jul 19, 2013

might try here
Untitled URL Link

6 bolt hub

Jake Collie

Member

charlie n

Well-known Member

mkirsch

Well-known Member

rustyfarmall

Well-known Member

36 Coupe

Well-known Member

greygoat

Well-known Member

504-1

Member

fixerupper

Well-known Member

cannonball

Member

Similar threads