(800) 853-2651
SHOP NOW

Ford 6610 brake shaft seals

R

rob bell

New User
Does aht one have a schecmetic diagram of a brake shaft seal and components for a Ford 6610 tractor ?? I am having trouble getting it all apart to replace the seals !! My books only show the schemetics for a cab model but I need one for a no cab version to get parts off the shaft???
Thanks to all
 

You have it in your 'puter. Go to CNH, then agriculture, then North America, then Parts and service, then Parts search, enter 6610, click on brakes.
 
The parts diagrams are available through newholland.com/na Follow the links for parts search.
Should just be a matter of unbolting whatever you see in front of you. Yours probably has the hand brake assembly... so you likely need to get the cable free from that, etc. Just snap a pic of it before you take it all apart.

Remember to drain some oil out of the rear end or elevate that side of the tractor considerably before removing the brake boot. Once you get the brake rod stripped clean, take a good sharp chisel and get behind the steel backer of the boot and force it from the axle housing. When installing the new seal... remove the spring from the boot, slide it onto the brake rod, seat the steel backer... make sure the boot is all the way up over the land on the rod... then replace the spring. Otherwise you'll probably tear the boot...

Rod
 
You must log in or register to reply here.

Similar threads

G
Ford 861 input shaft seals
Replies
6
Views
396
used red MN
U
M
Ford 555 leaking out of the side of the trans
Replies
3
Views
262
MiMisfit
M
A
Ford 851 input shaft seal
Replies
1
Views
106
Old Ford Mechanic
O
B
Ford 2000 PTO shaft seal leaking
Replies
2
Views
142
Bennett French
B
B
Ford 2000 PTO Output Shaft removal
Replies
10
Views
401
Bennett French
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top