Onan CCK

David G · Jun 4, 2013

I have an Onan CCK that is leaking oil around the pin that drives the ignition points. Does anyone have a part number?

Thanks,

Billy Shafer · Jun 4, 2013

If it still has the rubber boot on the point rod. Remove it. Onan found out it turned into an oil pump. Don't need it.Also check your crankcase breather. Round tube by the Carb. If it is clogged up. It will cause oil leaks.

Onan tech since 1980

David G · Jun 4, 2013

I will check.

So there is no seal?

Much appreciated.

David G · Jun 4, 2013

This was out of a refrigerator truck from the 60s.

Billy Shafer · Jun 4, 2013

The boot over the point rod. Was supposed to keep oil out of the point box. But instead it turned out to be an oil pump. Filling the point box with oil.I have thrown away a lot of them.

David G · Jun 4, 2013

If you run across a used cover, I will buy it from you, mine is missing.

Billy Shafer · Jun 4, 2013

Does yours have the large point box cover. Around two inches across. Or the smaller one. I have a contact that may have one.

David G · Jun 4, 2013

I will measure and post.

Onan CCK

David G

Well-known Member

Billy Shafer

Well-known Member

David G

Well-known Member

David G

Well-known Member

Billy Shafer

Well-known Member

David G

Well-known Member

Billy Shafer

Well-known Member

David G

Well-known Member

Similar threads