(800) 853-2651
SHOP NOW

Farmall H rebuild

D

Daniel Jessup

Member
i am completely 100% rebuilding a farmall H engine and want to know if the farmall super H overbore kit will go in the farmall H block. i know the sleeves will be really thin. i am going to put a farmall 300 (361479R1) engine head on it and going to use it for farmall work only.
 
Farmall Work only?? Sitting in the shed while the Deeres do the farming. LOL (couldn"t resist a little jab)
 
No they will not fit. You would have to bore the block and I don't think the old H block would be up to that.
 
another question i have is about painting the tractor. i hear of people using the paint for older tractors where you get the flaky rust off and then paint over the rust. i have done that with my super C and it turned out great and i used tractor/implement paint. i have been told to use a dupont imron paint but is it worth the money for the shine.i dont have a sand blaster and that is bad to use unless you take the whole tractor a part and then clean every part of it thoroughly. i was gonna use a wire wheel on a small grinder and the hood and grille sand it by hand and get it close to perfect but i do need a better hood though. the tractor will be used for farm work but will probably put it in a parade or 2 for hay rides and might take it to a tractor pull to show off.
 
You must log in or register to reply here.

Similar threads

C
Farmall H or M
Replies
10
Views
464
onefarmer
onefarmer
E
1940 farmall H trany whine after rebuild
Replies
12
Views
624
Janicholson
Janicholson
U
Old thread warning
2
Replies
27
Views
2K
plattman
P
K
farmall parts & diagrams Farmall H Steering source
Replies
2
Views
129
Janicholson
Janicholson
N
farmall m carburetor rebuild
Replies
9
Views
473
ncems1995
N
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top