oliver power booster problem

Anonymous-0 · Feb 27, 2013

my Oliver 880 power booster has a broken trough out bearing I don"t want to pull the engine. is there any way to change that?

Dr. Walt · Feb 28, 2013

NOPE, since the input shaft for the Transmission goes THROUGH the throw-out bearing, THROUGH the pressure plate, and THROUGH the clutch disc, & then into the pilot bearing in the flywheel; then I would have to say that it's a physical impossibility to replace the throw-out bearing WITHOUT separating the Engine from the Transmission. And, since you have to separate everything, DON'T replace just the throw-out bearing - replace everything, do a complete Clutch job.

J.Wondergem · Feb 28, 2013

Your power booster, or the main clutch throw out bearing, needs to be replaced? Also, you might want to post this on the Oliver page below.

Anonymous-0 · Feb 28, 2013

through out bearing.

Anonymous-0 · Feb 28, 2013

I mean throw out bearing, sorry.

Anonymous-0 · Feb 28, 2013

can I pull out the pto shaft out of the transmission?

J.Wondergem · Feb 28, 2013

(quoted from post at 19:21:50 02/28/13) can I pull out the pto shaft out of the transmission?

You'll have to pull the PTO shaft out of the back end before you do anything. It runs through the center of everything up to the flywheel, so live PTO.

oliver power booster problem

Anonymous-0

Well-known Member

Dr. Walt

Well-known Member

J.Wondergem

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

J.Wondergem

Well-known Member

Similar threads