(800) 853-2651
SHOP NOW

Snow moving picture

R

Rick Kr

Well-known Member
Picked up this 7'6" Meyer for a song, cylinders were shot. Blasted all the mounts off with the plasma cutter and welded up a receiver out of 2x2. Two hours and a little scrap steel.

The long term plan is to make a snowpusher with it. I have steel for the wings and braces, but I am going to wait until I convert the loader to the quick-attach.

We really need more snow here in mid-Michigan. I was playing in last nights snowfall of 2-3 inches, I had to hurry and get out there before it all melted.

Rick
a103672.jpg

a103675.jpg
 
Rick Gogle a place called ATI , attachments incorporated or something like that. They will sell direct and make the best quick attach for that loader then you can pick up what they call a blank plate, skid steer type and weld to your bucket. Makes a good set up. Most of the auctions in this area always have a pile of the plates that get down as low as 60 bucks or so .
 
I've got one just about like that Rick.
It pins into the bucket using the original plow mounts. Chains to the side/top.
I intend to hook it up in place of the bucket and use the tilt cylinders to turn it.
Haven't go a round tuit yet. ;)
Nice looking rig you have there!
 
Mine is pretty similar, only an oak 2x12 mounted on a Stanhoist loader on my JD A. Been doing the job for many years, not pretty, but cheap.
 
Rick,
Nice snow moving machine you have there. I bet that FWA comes in really handy. I spent about 4 hours today in my 1070 Case blowing snow for 4 different farm sites. Nice 25 degree day today here in Minnesota. Thanks for the pics.
Kow Farmer (Kurt)
 
That works well,Dad and I used the same plow and made quick attach for our JD 2555 we ran hyd lines from the rear to front to have power angle also, we plowed the county roads with it.
 
Thanks for the comments.

I am pricing the quick attaches this morning, a little more than I wanted to spend, but it is time to get one.

Rick
 
You must log in or register to reply here.
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top