Author	[Modern View]
mikekee 02-21-2013 11:46:56 64.147.226.158 Report to Moderator	novice here were is the dip stick for hydraulic fluid and were do you add it.bought and old tractor has a couple 1 12 90s by gear shift with a nut on top kinda thinking its suppose to go there but not sure on how much.stuck a zip tie down in it to get a level check and just got a drop at the bottom of tie 12 in tie. [Reply]   [No Email]
mowr 02-21-2013 16:07:23 66.213.10.5 Report to Moderator	Re: 404 IH in reply to mikekee, 02-21-2013 11:46:56   No dipstick. Just a pipe plug in the top of the torque tube just behind the bell (of the bell housing). Drain plug is on the right lower of the same housing.   [Reply]  [No Email]
mikekee 03-10-2013 12:12:42 64.147.226.158 Report to Moderator	Re: 404 IH in reply to mowr, 02-21-2013 16:07:23   Is this housing under the seat on the left side faceing tractor.,I need to drain the fluid.and you say the feed tube is by the shifter in front of seat.My bucket lifts slow and my hitch is very slow.........   [Reply]  [No Email]
mowr 02-21-2013 16:10:55 66.213.10.5 Report to Moderator	Re: 404 IH in reply to mowr, 02-21-2013 16:07:23   Transmission/rear axle housing takes gearlube; does not share with hydraulic system.   [Reply]  [No Email]
Ralph1111 02-21-2013 12:47:39 204.12.181.71 Report to Moderator	Re: 404 IH in reply to mikekee, 02-21-2013 11:46:56   If I remember correctly their is a pipe plug on left side near the back of the housing which would be the level check, you have all ready found the fill hole. Ralph   [Reply]  [No Email]
mikekee 02-21-2013 13:37:08 64.147.226.158 Report to Moderator	Re: 404 IH in reply to Ralph1111, 02-21-2013 12:47:39   And what type of hydraulic fluid should be used.   [Reply]  [No Email]
Janicholson 02-21-2013 14:56:21 74.60.94.18 Report to Moderator	Re: 404 IH in reply to mikekee, 02-21-2013 13:37:08   Hytran (IH) or equivalent. JD transmission fluid is fine. Read the label on all others to be sure it meets the Hytran spec. Jim   [Reply]  [No Email]