O/T Its getting close

Anonymous-0

Well-known Member
To do the big LIFT :wink:
11373.jpg
 
Yeah, and tell the videographer to KEEP SHOOTING, no matter what! If things go sideways, you can probably sell the video to one of those blooper outfits for enough to pay for the damage.
 
I just figgered you was gonna give up on having it lifted, and just hire a bunch of midgets to work for ya...
 
It can be done. A neighbor raised a building used for a hog grower high enough to get a road tractor and box trailer inside. Its now a tobacco stripping barn, about 14 ft. at the eaves. Joe
 
With helium being in such limited supply, it would cost a fortune to raise the roof with helium balloons. If you can find it, a 244 cu. ft. helium is about $350. The equivalent size oxygen is less than $50.
 
(quoted from post at 01:15:45 10/10/12) I am still waiting to see you get that roof on top of the walls.
am doing this all by me lonesome so its taking me a little longer then I thought, this is the first time Im doing some thing like this so I have ta scratch me heads lots..lol
 
So if walls are up and roof is next to them, and you have slanted ramp boards, lots of rope, pulleys and a tractor handy you can hitch rope to braced side of roof and pull it up slanted ramp, then over top plates of walls to close to finish location. pry bars for final locating, then nail down to center, then some bolts in predrilled holes in top plates to end of rafter or rafter ties. Amish do this with horse teams when moving or repairing storm damaged roof structures or sometimes working up new buildings when prebuilt trusses are used as a base for ground finished roof. Tilt roof with jacks to get clearance for a brace/rope or chain attach beam, ramps, brace end wall and pull. Alignment beams/boards guide roof onto walls in proper place, lag bolts to roof from underneath through the top plate-as noted predrilled pilot hole- and you have it tacked in place for final hold downs.
 
Just thought of something. The crews that raise the blue harveststore silos, don't they have a sysyem to raise stuff like this? Not shift it over the width of itself, but I would give one of them a call and see if they can get that on in a morning ...without incident...
 
I would do a lot more work on the structure first. Make sure it can take a few "hits and misses" from the lid.
 
Harvestores are put together roof first with top panel, then lower panels as the first ones are jacked up with 6-8 hyd jacks, run in unison. Similar to grain bins with hand cranked jacks. They do not have the ability to move anything sideways.
 
I'm waitin for the video when you lift that thing. I want to see the look on Smokey's face when you catch him taking a dump under there.....
 
I think I just re-invented a different way of raising a barn (roof). Built the walls, then trusses and rafters, sheething, and roofing materials..... I think they did that in the good ole days....lol...
Go Lyle!!!
 
(quoted from post at 23:19:40 10/09/12) boy ho boy got to git me a big bag of popcorn and sit back and watch. good luck to ya. Bob
ous gonna have to eat your popcorn fast, cause it will be spotted within an hour :wink:
 
(quoted from post at 14:48:28 10/10/12) I"d like to ask an obvious question that no-one has...."Why are you doing it this way"????
ts safer, easier, cheaper and turns a 3 man job into a 1 man job
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top