(800) 853-2651
SHOP NOW

Bobcat

K

Keith-OR

Well-known Member
All you guys and gals that might have a Bobcat (610)
that has a Wisconsin VH4D engine, I need a measurement!! I need the distance from the engine block to the inside vari-speed pulley.. I think it is some where around 1/2 inch.. I made a big mistake, had my pulley machined out to fit a straight shaft, but for got to get this measurement before hand..hhhhhhhmmm

And no the manual does not contain this info !!!!!

Thanks
Keith & Shawn(Gold medal winner, 445lb DL)
 
I got a 610, you need the distance between the engine and the inside sheve at the shaft, correct? I'll measure it in the morning, OK!!!
dan
 
Yes sir that is the measurement I need. The one from the inside sheave to side of motor.

Thanks

Keith
 
Hi sorry took soo long, just measured mine, got .468 between the sheave and the block between the bolts behind the oil filter. By the way do you know where to get after market clutches and bearings, also need bushings for the tilt on the bucket, old girl is getting kinda loose. Should have a place on here for old skid-steers too. !!!
dan
 
dannye, not sure which bearings you are needing, but if it is the main bearing on the variable speed jackshaft, those are Timkin bearings. I purchased them from my local bearing outfit, #G1104KRRB $30.26. There different qualities for those bearings.
I bought the top quality, as I did not want to do this over again down the road.

If you need the parts manual for the 610, I would be more than happy to email it to you. I also have the Complete Shop Manual.
 
I just go off the phone with my supplier, he told me that they can drop ship from manufacture to you.
I need bushings also for one side on bucket hydraulic cylinder. I will let you know the cost and part #, as soon as I get it ordered.

By the way my email is open

Thanks
Keith
 
You must log in or register to reply here.

Similar threads

H
Bobcat 610 drive belt
Replies
4
Views
461
hunt1032
H
H
Wisconsin engine in Owatonna 1200 skid loader ???
Replies
3
Views
539
John Achmann
J
C
Bobcat 610
Replies
4
Views
811
Conor H
C
T
Bobcat 610
Replies
5
Views
1K
Keith True
K
J
VH4D Wisconsin engine
Replies
2
Views
3K
JLanders
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top