(800) 853-2651
SHOP NOW

Carb gasket

V

Vern

Member
Where can I get a carb. to manifold gasket for a '48 S/A with the 113cuin engine?
I rebuilt the carb. but screwed up the afore mentioned gasket.

Vern
 
Pretty easy to cut your own from gasket material with a small ball peen hammer too if you happen to have a piece laying around.
 
cardboard like cereal boxes and oil filter boxes work fine too. I made one out of a Chicken McNugget box last week for our F-600 because we needed the truck in a pinch. I just tapped around the edges and cut it out with my pocket knife. I made a long trip with it the next day and it still isn't leaking. I saved a lot of time and a little money and the truck runs great.
 
I always keep different types and sizes of gasket material around and a shall ball peen hammer to make gaskets when they are hard to come by or cost all "H" lay the gasket on the opening then tap out two bolt holes across from each othe insert bolts them continue making gasket with the hammer abd a very sharp small knife.
Walt
 
You must log in or register to reply here.

Similar threads

N
1952/8N carb Gasket
Replies
2
Views
213
NW-FLORIDA
N
A
Ford 5000 head gasket
Replies
8
Views
399
used red MN
U
D
Marvel carb expert help needed
Replies
11
Views
943
docmirror
D
M
Question about head gasket replacement on a MF 135 with Perkins 3cly gas.
Replies
7
Views
339
Dieseltech
D
D
Rebuilt Carb Leaking into the Manifold
Replies
8
Views
386
DRDuetarg
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top