(800) 853-2651
SHOP NOW

IH 560 Hydra Touch valve

C

Craigswanson

New User
Just replaced the main hyd. pump in the 560, everything tests good for pressure and bypass valve operation. The Tele-depth valve works good and the first Hydra Touch valve is pretty good, i have it set on single action and operate my loader up,single action loader cyl.
My second Hydra Touch control is operating the bucket with two way cyl (rebuilt), when i first run the bucket it works pretty good, but after awhile it seems to loose travel in the lever and feels like it has "back pressure" on the valve so it does not operate up or down well, lever only moves a small amount from neutral and bucket moves very slow but plenty of power.
Is this an o ring issue, a spool, a orifice??? They no longer sell the rebuild kit or the valve and i hate to swap it out if I dont need to.
Thanks,
Craig
 
If your issue is in the valve itself , not a coupler or check valve restriction problem, I would guess the unlatching piston in the valve has the orfice peened partially shut . This will cause valve to fight you when trying to move it. The unlatching piston with a slot and orfice in it is on the end of valve with the two bolt cover so you can inspect with out tearing valve out. It is rare but have seen it happen.
 
Thank you Pete, I will pull the front cover and take a look (cover closest to the seat). Should i run a .040" drill bit through the hole?
Is there an easy way to pull the whole valve assembly out with leaving the valve body in the tractor so I can put it on a bench and clean it up and inspect it?
Thanks again
Craig
 
You must log in or register to reply here.

Similar threads

N
Ih 460 valve body leak
Replies
3
Views
200
gearheadbill
G
S
300 U loader valve ?
Replies
15
Views
373
Shelbygt
S
S
Loader valve
Replies
5
Views
313
GarryinNC
G
F
Diagnose 460 hydraulic value problem
Replies
8
Views
528
300guy
3
K
Ford 800/900 Hydraulic Remote - Auxiliary Port
Replies
8
Views
628
KJMClark
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top