Dunham Lehr - Farmhand loader ID needed

Anthony06070 · May 2, 2012

Bought a JD 1020 with loader which guys in the JD forum have helped me identify as a Dunham Lehr -Farmhand loader.

But, I am not sure if it is a Series 2 or Series 22. I am leaning towards the Series 2. Anyway to be sure? All markings are painted over.

What are the specs of the 2 vs the 22?

Much obliged.

JMOR · May 2, 2012

(reply to post at 08:01:55 05/02/12)

urely not the same LEHR that sells those crappy/junk/garbage/worthless Propane powered/'Green' lawn edgers, blowers, mowers & outboard mowers........or else it would have collapsed around the tractor just sitting idle! Ran less than 45 minutes out of the box, dropped a valve into cylinder, locked tight & Lehr says 'tough luck', we aren't going to do anything (through their farm-out warranty group.....for isolation purposes no doubt). One lesson here, don't buy anything that the selling store won't stand behind....Home Depot was selling these with instructions, "don't return to retailer , if problems exist return to Lehr customer service 1-800-XXXXXX ONLY. Very bad!

Leroy · May 2, 2012

You have a single tilt cylinder on yours, and so that is probably a 22 then as some lit I have pictures a different setup than I had and I had the two cylinders for the bucket tilt. Mine was on a Ford 4000 (4100) and repainted so bould not tell what it was, Only could tell it was a Dunham from being simulat to pic in my lit but in there they are white paint.

rrlund · May 2, 2012

Only thing that looks different than my 22 on that one is where that round bar welds on in front. Yours tilts out a little and mine comes straight down.

Anthony06070 · May 2, 2012

True on that point. I also think the 22 had another set of supports going from back to front.

Dunham Lehr - Farmhand loader ID needed

Anthony06070

New User

JMOR

Well-known Member

Leroy

Well-known Member

rrlund

Well-known Member

Anthony06070

New User

Similar threads