(800) 853-2651
SHOP NOW

One-point Fast Hitch (140 etc.)

M

MapleSprings

Member
I am trying to make a couple low-tech implements for the 1-point on my 140. I have had only one around to copy and did so quite accurately, but the fit seems sloppy and it's causing some usability issues for my simple design.
Does anyone have a factory original point on an implement that you could measure? Or do you simply know the factory dimensions in your head?
Thanks for any help.

Mark Heidmann
 
Is this the one you are asking about? I "think" it was made for a one row tobacco setter.
a67080.jpg
 
At the notch closest to the tip this one is 1 1/16 inches. At the point where the taper begins it is 1 inch but it decreases as you reach the tip. HTH.
 
here you go, print out the two and join together
http://www.cleancomputes.com/Cub/Sketches%20or%20Plans/Drawings-Sketches-Pictures/Dan%20Huggler/One%20Point%20Hitch/fast%20hitch%20point%20part%20b.pdf
http://www.cleancomputes.com/Cub/Sketches%20or%20Plans/Drawings-Sketches-Pictures/Dan%20Huggler/One%20Point%20Hitch/fast%20hitch%20point%20part%20a.pdf
 
You must log in or register to reply here.

Similar threads

A
Field Cultivativator for Farmall 140 fast hitch.
Replies
3
Views
483
peteL
P
F
Using fast hitch implements on 3 point tractor
Replies
8
Views
580
MARK ROBKE
M
5
Farmall 100 Fast Hitch Diagonal Link
Replies
2
Views
219
couv
C
K
farmall one point hitch
Replies
5
Views
688
khouse6
K
C
Thoughts on Ballast Block/Barrel for Three Point?
Replies
17
Views
1K
David Snipes
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top