Mike Klein
New User
This message is a reply to an archived post by John Kenny on November 09, 2011 at 04:00:12.
The original subject was "Allis G, basket weeder setup".
I have seen a tube extender for G which bolts between the front and center torque tube.
I can forward you the plans. If you send your email. Length depends upon the confidence in your welder. If your tractor is hydraulic then you might need to extend the hoses.
I have also taken the A fram single row cultivator off and replaced it with a 2" square bar. The square set up allows you to use danish S tines available through Agri Supply.
To make the Square bar fit into the bracket you need to have someone shave off about 1/4 inch off two opposing corners then drill a 7/16 hole to secure the bar to the cultivator bracket. I used a 1/4" thick walled squared tube. Consider where you want the brackets to attach. You may need to adjust the lift assembly to accept a wider spacing so you have flexability in spacing the tines.
You can also just drop in a 2" diamond (square turned 45 degrees) and use it as a diamond bar but these diamond brachet attachments get expensive.
The original subject was "Allis G, basket weeder setup".
I have seen a tube extender for G which bolts between the front and center torque tube.
I can forward you the plans. If you send your email. Length depends upon the confidence in your welder. If your tractor is hydraulic then you might need to extend the hoses.
I have also taken the A fram single row cultivator off and replaced it with a 2" square bar. The square set up allows you to use danish S tines available through Agri Supply.
To make the Square bar fit into the bracket you need to have someone shave off about 1/4 inch off two opposing corners then drill a 7/16 hole to secure the bar to the cultivator bracket. I used a 1/4" thick walled squared tube. Consider where you want the brackets to attach. You may need to adjust the lift assembly to accept a wider spacing so you have flexability in spacing the tines.
You can also just drop in a 2" diamond (square turned 45 degrees) and use it as a diamond bar but these diamond brachet attachments get expensive.
