alan.donta
New User
i have an 87 1010 and am looking for a throw out bearing for the pto dealer says they are unavailable any help would be great
- Thread starter alan.donta
- Start date
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
Sorry JD 1010 production ceased in 1965 not '87
When a dealer gives you the runaround, it"s time
to get part numbers, JD part numbers, The part
number stamped on the assembly, and assigned by
whomever JD purchased it from, and finally some
dimensions, such as Inside diameter, outside
diameter, thickness, or width...then, if you
collect catalogs, like me,(and I"ve gone to
Timken and Fafnir bearing schools)and checking
out whats available...or...go to a darn good
bearing and powertrain supply house, and give
them your information.
to get part numbers, JD part numbers, The part
number stamped on the assembly, and assigned by
whomever JD purchased it from, and finally some
dimensions, such as Inside diameter, outside
diameter, thickness, or width...then, if you
collect catalogs, like me,(and I"ve gone to
Timken and Fafnir bearing schools)and checking
out whats available...or...go to a darn good
bearing and powertrain supply house, and give
them your information.
buickanddeere
Well-known Member
Serial number? There was re-design at 31,001 and
another at 42,000. Some running changes here and
there through production.
There is a parts list here
http://jdpc.deere.com/jdpc/servlet/com.deere.u9049
0.partscatalog.view.servlets.HomePageServlet_Alt
Keep us posted with info and progress and we'll
get the old girl running.
The persons dealerships hire for minimum wage
at the parts counter sometimes lack motivation,
ability, knowledge,experience and/or manners.
another at 42,000. Some running changes here and
there through production.
There is a parts list here
http://jdpc.deere.com/jdpc/servlet/com.deere.u9049
0.partscatalog.view.servlets.HomePageServlet_Alt
Keep us posted with info and progress and we'll
get the old girl running.
The persons dealerships hire for minimum wage
at the parts counter sometimes lack motivation,
ability, knowledge,experience and/or manners.
Tx Jim
Well-known Member
- Location
- Coyote Flats, Texas
If I looked up the correct part # T10583 RING (NO LONGER AVAILABLE)(parts key # 16)
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy