(800) 853-2651
SHOP NOW

Loader for 135 tractor?

I'm not very familiar with the Ford/MF line.But with a very little welder/torch work,Im sure you can make it fit.There is an 8N Ford with a JD#35 loader in this neighborhood,so anything is possible.Steve
 
Years ago we put a Ford loader on a MF 135. Don't recall the model number, but I remember it had single acting lift cylinders and a single DA cylinder on the bucket. The loader sub-frame bolted in at the rear axles with no problem. Our MF dealer used a large plate of steel at the front, which was bolted to some existing holes under the front, and the loader subframe was bolted to it. The plate was mounted vertically, and I would guess it measured about 8" x 24", probably at least 3/8's thick. I remember being amazed that the plate was bolted up and the loader sub frame arms seemed to be an exact fit without any requrired modification. The rear axle mounting holes also resulted in the uprights being at the correct width without any modificatons needed. Only downside to the project was that we just tapped into the hydraulic system in a manner that required us to chain down the 3 point lift arms to use the loader. Ran the pressure line to a dual spool controls mounted on a plate welded to the upright.
 
You must log in or register to reply here.

Similar threads

C
R&G Loader for MF Tractor
Replies
1
Views
153
DeltaRed
D
B
Model 135 with Loader
Replies
2
Views
270
MKinON
M
B
Massey Ferguson Model 32 Front Loader
Replies
0
Views
195
bl@ckdog1
B
D
Massey Ferguson 2200 rear grinding noise
Replies
7
Views
297
Dscicluna1
D
I
Massey Ferguson Jack
Replies
6
Views
904
ferg20
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top