Draw bar pin Finally out

charlton c · Jan 4, 2012

Well we finally got the draw bar pin out .Holy cow I wasn't expecting it to be this hard.We welded a nut to the pin then took some 3/4 althread threaded it in the nut then took a piece of 2 inch pipe slid it over the althread put two washers on the end with a nut .We used a 3/4 impact while heating the draw bar and used a hammer on the end of the bar.It was slow but it worked.Thanks for the ideas.

showcrop · Jan 4, 2012

So was it rusted in? Like I said earlier I've never seen one that wasn't well lubricated by hydraulic leaks.

Draw bar pin Finally out

charlton c

New User

showcrop

Well-known Member

Similar threads