(800) 853-2651
SHOP NOW

ihc300 utility tractor

T

tractornutty

New User
I am working on a ihc 300 utility. The tractor set for several years and the hydraulics did not work. I changed the fluid tuned up the engine and got it running well. I still had no hydraulics. I removed the pump and tore it apart and it was worn pretty bad. Ordered new pump and installed. Fired it up and worked air out and everything started working. power steering works. rear draw bar works front bucket tilt works. but the bucket lift will not work. Irebuilt the control valves for the bucket tilt and lift with new o rings. lift cylinders still wont work. lift cylinders are single acting and everytime i take a line loose i get alot of air out with the fluid. there are no plugs installed on the cylinders to bleed the air out. any Ideas?
 
There is a switch on the end of the valve that selects single or double acting output. That switch has a roll pin through it that turns in a sheet metal clip. Be sure it is set to S for single acting, and not D for double acting. Also make sure the reservoir is full when the bucket is down. Jim
 
I took the hoses off of the tilt bucket and put them on the lift cylinders and it lifted the bucket up using the bucket tilt valve instead of the lift valve. Does any one know where I can get another valve?
 
You must log in or register to reply here.

Similar threads

T
Loader Control Valves or Cylinder Failure?
Replies
7
Views
350
todintexas
T
S
Help needed (and greatly appreciated!!) 1962 JD 1010c
Replies
7
Views
458
wore out
wore out
W
Broke the loader joystick
Replies
8
Views
894
Blackhole49
Blackhole49
F
Hydraulic fluid fill location on 187D
Replies
3
Views
217
fosterdude-HT
F
P
BSD 444 piston height
Replies
8
Views
514
Destroked 450
Destroked 450
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top