JD 60 carb

JD60Dan · Oct 23, 2011

Wondered if someone could tell me what the settings are for a marvel shebler dltx81 carburetor on my JD 60? thanks

BCnT · Oct 24, 2011

i havent run into a MS carb that wont run with both needles set to 1.5 to 2 turns out...fine tune after you get it warmed up good.

Mark-Ia · Oct 24, 2011

load screw is 2 1/2 turns. idle screws approximately 1 turn. After yu start the tractor short out or remove the #1 plug wire and then adjust the idle screw on #2 cylinder until you get maximum rpm. do the same with #2 plug wire and adjust #1 idle screw to get maximum rpm. Reinstall plug wires and turn in the idle screw to match that to the slower cylinder.

JD60Dan · Oct 26, 2011

Thanks guys, you helped out alot!

JD60Dan · Oct 26, 2011

One more question, as you sit on the tractor which is cylinder 1? Thanks again.

JD 60 carb

JD60Dan

New User

BCnT

Well-known Member

Mark-Ia

Well-known Member

JD60Dan

New User

JD60Dan

New User

Similar threads