Anonymous-0
Well-known Member
Will a 2000 4sp ford handle a 467 haybine
- Thread starter Anonymous-0
- Start date
Ragsdale Farms
Member
It should, I used to pull a 7 ft john Deere haybine with a 1972 Ford 2000 gas burner I couldn't tell it was back there only problem I had was the hydraulics were slow to raise it but it did a great job pulling it our 9 ft new Holland haybine that we have now only calls for 40 hp but I would say yes it should pull it just fine goodluck!!
Bob N.Y.
Well-known Member
- Location
- Norway, N.Y.
A 2000 4 speed does not have live PTO. That will make it inconvenient to run a haybine.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy