|
| |
| Stationary Engines Discussion Forum |
Topic: Re: Wisconsin VF4D timming
[Show Entire Topic] [Return to Forum]
| Author |
[Modern View]
|
| JOB
07-21-2011 18:51:20
74.36.129.132
|
Remove the screen that covers the flywheel.That will expose the timing marks that are on the flywheel shroud. The flywheel is marked with the letters DC near one of the flywheel fins. the fin is further identified by an X mark cast on the end of the fin. Turn the engine over until edge of the marked fin on the flywheel is on line with the mark on the vertical line of the shroud. At this point the key way for mounting the flywheel is also on top. The magneto should now be fitted to the engine so the X marked tooth of the magneto gear is visible through the lower half of the inspection hole.If the magneto is properly timed the impulse coupling will snap when the DC X marked fin lines up with the center line of the number 1 and 3 cylinder as marked on the flywheel shroud.
|
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
