|
Support YT Subscribe Today!
|
| Restoration & Repair Tips Board |
Topic: Inside of fuel tank rusty, now what?
[Return to Forum]
| Author [expand] |
[Modern View]
|
| RAG
11-04-2009 19:24:01
67.142.130.26
19257
|
The inside of the WD45 gas fuel tank I have is rusty, keep getting contamination in the fuel lines, etc. What is the best way to clean or seal? By the way, the tank already has a finish paint coat on the exterior. The folks doing the restoration did not deal w/ the problem w/ inside rust before they finish painted the tank. |
|
[Reply]
[Send Email] |
|
| J.Wondergem
11-13-2009 17:25:34
4.142.210.105
19310
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| The last one I cleaned, I used electrolysis, like Brian Jasper said. Sure cleaned up nice. |
[Reply]
[No Email] |
|
| Tony S.
11-06-2009 19:11:57
74.47.30.106
19277
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| If there is no water in the tank, the rust is not progressing. Take the tank off, rinse out the loose rust and put it back on. |
[Reply]
[Send Email] |
|
| Brian Jasper co. Ia
11-06-2009 12:31:48
67.142.130.24
19270
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| You can clean it by electrolysis. Fill the tank with the solution and drop your anode into the solution being careful to not touch the tank. One clamp from the battery charger goes on the anode and the other to the tank. Might take a little longer than a couple hand fulls of nails, nuts, bolts and mechanical action, but it should do just as good a job. |
[Reply]
[No Email] |
|
| rhouston
11-06-2009 13:43:21
24.97.211.2
19271
|
|
Re: Inside of fuel tank rusty, now what? in reply to Brian Jasper co. Ia, 11-06-2009 12:31:48
|
| Don't know about his tank but the one on my international has a baffle inside the tank so he may only be able to clean half the tank. The gap between the baffle and the outside of my tank is too small to get an anode through without shorting to the tank. On the up side the inside of mine looks as good as the day it was made even though the out side was very rusted. |
[Reply]
[No Email] |
|
| Brian Jasper co. Ia
11-06-2009 17:31:57
67.142.130.48
19273
|
|
Re: Inside of fuel tank rusty, now what? in reply to rhouston, 11-06-2009 13:43:21
|
| It should work. I'm about 98% sure the WD45 tank doesn't have a baffle in it. I have a CA and D17 and neither of them have a baffle in the tank. |
[Reply]
[No Email] |
|
| ncBrad
11-06-2009 07:58:19
67.249.162.77
19268
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| I have dealt with this problem in motorcycle tanks a few times. I have put a small amount (1 or 2 cups) of solvent...(gas, kero) in the tank along with a couple of good handfuls of nuts and bolts and sloshed the tank around including upside down. After knocking the loose rust off with this procedure I have had great success with mixing up some fiberglass resin and coating the inside of the tank by pouring into the fill hole and rotating the tank in all directions. Make sure the outlet is plugged with a rag, ect. I have done this a few times and have had no problems. Brad B. |
[Reply]
[No Email] |
|
| ScottyHOMEy
11-06-2009 05:50:26
70.105.255.111
19267
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| | You don't mention a leak so I'll assume it's just loose rust running around inside, so sealer is kind of overkill. And since it's painted up nice, I'll also assume you're not game for throwing a coule of fistsful of nuts and washers in theere and strapping it to another tractor wheel and taking it for a drive. Best bet is what others have suggested about letting it work its way out as much as it's going to and servicing the sediment bowl and screen unitl it's no longer a problem. YOu might also see if you can find some sort of magnet laying around, something you can get a hook or a wire onto and letting it down through the filler and letting it sit on the bottom, near the outlet. Depends on what kind of steel the tank is made of whether it will grab the rust or not, but it can't hurt and might help. If it does grab the rust you can pull it out and clean it off a few times until it's no longer a problem. |
[Reply]
[No Email] |
|
| JMS/.MN
11-06-2009 14:27:55
209.237.107.155
19272
|
|
Re: Inside of fuel tank rusty, now what? in reply to ScottyHOMEy, 11-06-2009 05:50:26
|
| I had an extra tank mount (AC WD), so I bolted it to a cement mixer, put in the nuts, and let it run- Mounting will not hurt the paint job. |
[Reply]
[No Email] |
|
| ProudCubOwner
11-06-2009 05:06:41
67.63.68.13
19266
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| They have some tank sealer kits for sale on this website. I have a cub so I went to Farmall IH then to IH tractor parts then selected cub. I think it was under fuel system/air intake category. |
[Reply]
[Send Email] |
|
| old
11-05-2009 08:59:24
4.245.5.236
19265
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| I agree with Rusty. I have a D-17 that has a lot of rust in the tank and it has a GOOD sediment bowl WITH a GOOD screen in it. I do have to dump the sediment bowl often but it still runs well and as long as it does its job and runs well I'll let it keep on filling the sediment bowl with rust |
[Reply]
[Send Email] |
|
| JMS/.MN
11-05-2009 08:32:10
209.237.107.155
19264
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| Lots of ways to clean and treat it without destroying the outside paint. When done, before installing the sediment bowl fixture, push a short length of plastic tubing into the top of the fixture, so it sticks up into the tank maybe an inch. Keeps the bottom feeders (I call them democrats) from sliding around the tank and plugging the line. |
[Reply]
[No Email] |
|
| rustyfarmall
11-05-2009 06:51:04
209.152.78.140
19262
|
|
Re: Inside of fuel tank rusty, now what? in reply to Rexalot, 11-04-2009 19:24:01
|
| A good sediment bowl with top screen in place will catch ALL of those contaminants BEFORE it can get into the fuel lines. Replace the sediment bowl, clean it regularly, and just live with the rusty tank. Eventually the lions share of that rust will have been captured, and then there will be no more problems. |
[Reply]
[No Email] |
|
| cd1
11-05-2009 06:31:23
67.234.156.27
19261
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| POR15 fuel tank repair kit. google it |
[Reply]
[No Email] |
|
| Cameron Smith
11-05-2009 04:59:00
71.10.251.173
19260
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| Any good parts and restoration supply company will have tank sealer. Just be sure to follow the directions! |
[Reply]
[No Email] |
|
| patsdeere
11-04-2009 21:37:20
24.5.251.100
19258
|
|
Re: Inside of fuel tank rusty, now what? in reply to RAG, 11-04-2009 19:24:01
|
| Search the archives. The topic has been covered many times. |
[Reply]
[No Email] |
|
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
|
Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
|
Home
| Manuals
| Parts
| 12-Volt Kits
| Carburetors
| Radiators
| Engine Kits
| Videos
| Books
Copyright © 1997-2008 Yesterday's Tractor Co. - A Washington State Corporation
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
|
|
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|